Laserfiche WebLink
11.1 — ANNUAL WEEDS — Water Carrier Volumes of 10 to 40 Gallons per Acre <br />Apply 1 to 2 quarts of this product per acre. Use 1 quart per acre if weeds are less than 6 inches tall and 1.5 quarts per acre if weeds are 6 to 12 inches tall and 2 quarts <br />per acre if weeds are greater than 12 inches tall. <br />These rates will provide control of weeds listed in the annual weed control tables when water carrier volumes are 10 to 40 gallons per acre for ground applications. Older, <br />mature (hardened) annual weed species may require higher rates even of they meet the size requirements. <br />11.2 — ANNUAL WEEDS — Hand -Held or High -Volume Equipment <br />For control of weeds listed in the "ANNUAL WEEDS RATE TABLE", apply a 0.5 percent solution of this product to weeds less than 6 inches in height or runner length. Apply <br />prior to seedhead formation in grass or bud formation in broadleaf weeds. For annual weeds over 6 inches tall, or unless otherwise specified, use a 1 percent solution. <br />For best results, use a 2 percent solution on harder -to -control perennials, such as bermudagrass, dock, field bindweed, hemp dogbane, milkweed and Canada thistle. <br />When using application methods that result in less than complete coverage, use a 5 percent solution for annual and perennial weeds and a 5 to 10 percent solution for <br />woody brush and trees. <br />12.0 — PERENNIAL WEEDS RATE TABLE (ALPHABETICALLY BY SPECIES) <br />Apply to actively growing perennial weeds. <br />NOTE: If weeds have been mowed or tilled, do not treat until plants have resumed active growth and have reached the recommended stages. <br />Repeat treatments may be necessary to control weeds regenerating from underground parts or seed. Repeat treatments must be made prior to crop emergence. <br />Unless otherwise stated, allow 7 or more days after application before tillage. <br />Do not treat when weeds are under drought stress as good soil moisture is necessary for active growth. <br />For hand-held sprayers, prepare the desired volume of spray solution by mixing the amount of this product in water as shown in the following table: <br />Spray Solution <br />Desired Amount of GlyStar® Pro <br />Volume 1/2% 1% 1-1/2% 2% 5% <br />10% <br />1 Gal 2/3 oz 1-1/3 oz 2 oz 2-2/3 oz 6-1/2 oz <br />13 oz <br />25 Gal 1 pt 1 qt 1-1/2 qt 2 qt 5 qt <br />10 qt <br />100 Gal 2 qt 1 gal 1-1/2 gal 2 gal 5 gal <br />10 gal <br />2 tablespoons =1 fluid ounce <br />WEED SPECIES <br />Alfalfa <br />Alligatorweed <br />RATE <br />(QT/A) <br />1-2 <br />4 <br />WATER <br />VOL. (GPA) <br />3-10 <br />3-20 <br />HAND-HELD <br />% SOLUTION <br />2% <br />1.5% <br />COMMENTS <br />Make applications after the last hay cutting in the fall. Allow alfalfa to regrow to a height <br />of 6 to 8 inches or more prior to treatment. Applications should be followed with deep <br />tillage at least 7 days after treatment, but before soil freeze-up. <br />Partial control. Apply when most of the plants are in bloom. Repeat applications will be <br />required to maintain control. <br />Anise (fennel) <br />r <br />1-2% <br />Apply as a spray -to -wet treatment. Optimum results are obtained when plants are treated <br />at the bud to full -bloom stage of growth. <br />Bahiagrass <br />3-5 <br />3-20 <br />2% <br />Apply when most plants have reached the early head stage. <br />Bentgrass <br />1.5 <br />10-20 <br />2% <br />For suppression in grass seed production areas. For ground applications only. Ensure <br />entire crown area has resumed growth prior to a fall application. Bentgrass should have at <br />least 3 inches of growth. Tillage prior to treatment should be avoided. Tillage 7 to 10 days <br />after application is recommended for best results. <br />Bermudagrass <br />3-5 <br />3-20 <br />2% <br />For control, apply 5 quarts of this product per acre. For partial control, apply 3 quarts per <br />acre. Treat when bermudagrass is actively growing and seedheads are present. Retreat- <br />ment may be necessary to maintain control. <br />Bermudagrass, <br />1-1.5 <br />5-10 <br />2% <br />Apply 1.5 quarts of this product in 5 to 10 gallons of water per acre. Apply when water <br />water (knntgrass) <br />bermudagrass is 12 to 18 inches in length. Allow 7 or more days before tilling, flushing <br />or flooding the field. <br />Fall applications only: Apply 1 quart of this product in 5 to 10 gallons of water per acre. <br />Fallow fields should be tilled prior to application. Apply prior to frost on water bermuda- <br />grass that is 12 to 18 inches in length. <br />This product is not registered in California for use on water bermudagrass. <br />23 (continued) <br />