Laserfiche WebLink
CITY OF SOUTH BEND <br />round cutout in the squad bench lid. Both the trash can and the sharpes container <br />may be removed from the squad bench by lifting up a sectioned portion of the <br />squad bench lid. <br />Lid Squad Bench Single WIBio»Waste 170" Std Model only <br />SQUAD BENCH LID <br />The squad bench shall have a full length lid that shall be manufactured from three <br />quarter inch birch. The lid shall be covered in color coordinating high pressure <br />laminate. <br />Handle, Trimark, Squad Bench, ST© <br />SQUAD BENCH LATCH <br />The squad bench lid shall be secured with a paddle handle that latches <br />automatically when the squad bench lid is closed. The latch shall hold the lid <br />secure during transit and shall not open unless the handle is lifted. <br />Strut Gas 60 LB Installed ILOS Mods <br />SQUAD BENCH HOLD OPEN <br />When the squad bench lid is lifted, it shall be held in place by a 60 pound <br />pneumatic hold open. <br />CS Splint,Custom <br />CURBSIDE SPLINT CABINET <br />A cabinet shall be located above the squad bench near the headliner. The cabinet <br />shall be 60.75" long X 5.00" high X 7.00" deep.divided into 3 sections. All are to <br />be rear of the radio bay in the forward portion. <br />Radio bay is to be approx 12" long X 5.00" high X 7" deep. It will have a radio <br />faceplate with a Havis cutout panel and a headset plug. <br />H, Cabinet, Inside/ Outside Access <br />Cabinet is rear of the telemetry area. <br />15.00" H x 26.00"W x ISM <br />10083-0016 08/27/18 <br />52 <br />