Opening of Bids - Spec S - One or More 2018 or Newer Emergency Medical Vehicle - Fire Service Inc - Part 1

Home Browse Search

A Stryker Power Load cot mount shall be supplied. It must accommodate the Stryker Power Pro XT. Y44 N_ The cot mount shall be located in the center of the patient compartment. 23.2 ASSIST RAILS One [1] 90" long, 1.50" diameter, smooth satin finished overhead grab rail shall be provided and securely fastened to the ceiling over the primary cot. One [1] 60" long, 1.50" diameter, smooth satin finished overhead grab rail shall be provided and securely fastened over the squad bench. The grab rails shall be fastened with bolts, washers and nuts of the appropriate dimension, through the interior ceiling panel and through the .090" aluminum accessory plate welded into the roof structure. Assist rails fastened with self -tapping machine screws are not acceptable. These grab rails must meet or exceed AMD Standard 008, Load Test for Ambulance Patient Compartment Grab Rail. Y,C.e N_ 23.3 SIGN Two self-adhesive "NO SMOKING OXYGEN EQUIPPED" and "FASTEN SEATIBELT" sign (1) shall be installed in the 1st action area. Y-K—N— 24.0 OXYGEN The medical oxygen system shall be capable of storing and supplying a minimum of 3000 liters of oxygen. A suitable high-pressure hose shall be provided. The concealed oxygen supply hose shall be .250" ID, .50" OD nylon base with polyester fiber reinforcing. This electrically conductive hose shall be certified to 1,875 psi and have a 7,500 pound burst rating. The fittings shall be DISS and flare, and be securely crimped to the barbed fittings by means of compressed copper sleeves. Oxygen supply hose shall be routed through the ceiling of the ambulance body and be secured with non-abrasive plastic "C" clamps. Oxygen lines should not be encased in insulation and should be free moving to enable easier maintenance and repair. The entire oxygen system shall be subjected to a 155-psi leak test for 24- hours before installation of panels or covers that may obscure or hide the system components. After the vehicle is completed, a test as prescribed by AMD Standard 015 shall be conducted for a period of four (4) hours to insure system integrity. This test shall be performed using nitrogen gas to purge the lines of all moisture and foreign debris. Upon completion of the test, the lines shall be bled free of nitrogen and capped. This medical oxygen system shall meet or exceed AMD Standard 015, Ambulance Main Oxygen System Test. Y 24.0.1 The oxygen system shall have three (3) outlets, (2) on action area wail and (1) over squad bench. The department shall specify the brand of quick -connectors to be used. A compartment shall have fully adjustable stainless steel rings for the 02 tank. The rings shall be located in the front of the compartment (tank will be provided by the department). Y,�LN_ 24.0.2 Oxygen outlets to be Cemtron/NCG brand Y-;<N- 56