Laserfiche WebLink
area. <br />7.28 FENDERETTES <br />Formed, rubber fenderettes shall be provided around each rear wheel well opening. <br />They shall help diminish damage to the wheel well area of the body caused by <br />stones and road debris. <br />Y_,,,/N <br />7.29 LICENSE PLATE <br />A Cast Products model #LP0002-1 rear license plate holder (or equal) shall be <br />recessed into the rear of the body on the driver's side between the kick plate and <br />turn signal. It shall be constructed of polished cast aluminum and have two [2] LED <br />top lights to illuminate the plate. The bezel shall be mounted to the body with <br />stainless steel screws and include a .060" thick closed cell foam gasket to prevent <br />moisture from seeping behind the bezel. <br />Y /N <br />7 <br />8.0 INTERIOR PATIENT COMPARTMENT COMPONENTS <br />Patient Compartment Sound Levels: This vehicle shall provide an interior working <br />environment in which the ambient noise level is less than 80 dB as measured <br />according to AMD Standard 006, Sound Level Test Code for Ambulance <br />Compartment Interiors. <br />Patient Compartment Carbon Monoxide Levels: This vehicle shall provide an interior <br />working environment in which the carbon monoxide level is less than 10 ppm as <br />measured in accordance with AMD Standard 007, Carbon Monoxide Levels for <br />Ambulance Compartment Interiors. <br />Y_N_/ <br />8.1 CABINET GLASS <br />All cabinet doors incorporating acrylic glass, as sliding or hinged windows shall have <br />.250" thick smoked acrylic, Plexiglas@ as the standard material and 3/8" where <br />otherwise specified. <br />8.2 STAINLESS STEEL ROUND LATCHES Y7ZN <br />Stainless Steel Round Southco locking latches (or equal) shall be provided on each <br />door where applicable. Y_N_/ <br />8.3 CABINETRY <br />The cabinetry in the patient compartment shall have picture framed window face <br />fronts fabricated from lightweight smooth aluminum material and laminated with a <br />minimum .028" Formica (or approved equal). The shelves and the supporting <br />structure shall be non -wood material and laminated with a minimum of .028" Formica <br />on both sides. <br />Non -supportive partitions shall be lightweight smooth aluminum material and <br />laminated with a minimum of .028" Formica on both sides. All vertical outside <br />corners and protruding edges of overhead storage shall be capped with 5 radius <br />satin finish anodized aluminum moldings or padded vinyl. <br />46 <br />