No. 2687 approving/authorizing the execution of an addendum to the Master Agency Agreement (Trade Drive Project)

Home Browse Search

• • 10 APPENDIX "A" BASIC SERVICES BY ENGINEER A. The ENGINEER will provide the field survey required for preparation of design plans for the Project in conformance with the requirements of the Indiana Department of Transportation Design Manual, Part III, Location Surveys, a copy of which is on file with the ENGINEER and same is incorporated herein by reference and is made a part hereof. Necessary field survey for the project will include (See Exhibit A): a. Complete topographic data along proposed Trade Drive from Lathrop Drive to 1,700 feet north of the Lathrop Drive, approximately 1,700 feet in length. Width of the topographic survey is 75 feet both sides of the proposed centerline (total width approximately 150 feet). b. Complete topographic data for one existing retention basin (650 feet by 650 feet) of approximately 8 to 10 acres in size on the west side of Trade Drive. C. Establish and reference alignments along each surveyed line. Set and Reference control points at 500 foot intervals. Set Vertical Bench Marks at both ends of the project limits and at 500 foot intervals. d. Locate surface evidence of known buried utilities and utility lines, if marked by others. Indiana Plant Protection to be contacted for locate. Locate known manholes, inlets and provide pipe sizes and invert elevations, for any sewer entering or crossing the proposed survey limits. Locate drainage structures under roadways and driveways, including types and inverts. e. Property lines and right of ways will be placed on topography using existing property irons, and other evidence found together with subdivision plats and last deed of record, if available. Right of way is expected to be acquired for this project. A Location Control Route Survey Plat will be prepared. B. The Project, as described herein, shall consist of the following (See Exhibit A): 1. Design of Trade Drive from Lathrop Drive to 600 feet north of the Lathrop Drive, approximately 600 feet in length including bus turnaround. The design shall include a two -lane, 36 -foot width roadway with new asphalt pavement, curb, and a storm sewer system. The design speed of Trade Drive will be 35 mph. a. The ENGINEER shall provide pavement marking plans and signing plans in accordance with the Indiana Manual on Uniform Traffic Control Devices (IMUTCD). b. The ENGINEER will design and prepare roadway lighting plans for Trade Drive — in accordance with the OWNER's standards. 1 of 6 Appendix "A"