Laserfiche WebLink
the axle and outboard of fi-ame rails. The designed ride <br />height shall maintain original suspension's drive-lin�e <br />geometry. <br />Tracking Bar: <br />The suspension shall utilize a lateral control rod (tracking I <br />YE NO <br />bar) to maintain side to side axle position related to the <br />chassis ftame. Wear shoes, mounted to the sides of the <br />frame rails are not ace -2table. <br />Hydraulic <br />All hydraulic lines, fittings, reservoirs and valves shall be <br />(Y��NO <br />System: <br />protected against "stone pecking". Abrasion covers, such <br />as nylon convolute loom over the lines are required, The <br />entire assembled system shall be tested for leaks at every <br />fitting con ection point. <br />Mechanical <br />All fasteners related to the suspension assembly are <br />------ <br />ES/ 0 <br />Quality <br />considered critical. All fasteners shall be tightened to the <br />Assurance: <br />manufacturer's recommended torque by the primary <br />installation mechanic. A secondary mechanic shall "put a <br />wrench" and re -torque ALL of the fasteners and then spray <br />a contrasting color of'paint onto the heads and nuts of each <br />fastener. <br />Suspension <br />A suspensionj ounce clearance study shall be performed <br />ES 0 <br />Jounce Study: <br />throughout the full range of suspension travel to ensure <br />adequate clearance of suspension, ftame and brake <br />components. Test results shall be documented and <br />sup lied in the owner's manual. <br />Kneeling <br />The rear suspension shall kneel when the triggering device <br />0 <br />Feature <br />is activated AND an enable switch, located in the cab <br />Enable: <br />console is activated. <br />Kneeling <br />The kneeling feature shall activate in PARKr position only. <br />VVN C <br />Feature <br />The kneeling feature shall NOT activate in any forward or <br />Activation: <br />reverse gear. The above rear suspension shall kneel when <br />the trailing rear access door is opened, <br />iquid Spring <br />Must include up to 16 hours of training for up to 4 <br />S <br />6�� <br />Training <br />technicians. <br />I VA <br />