Laserfiche WebLink
the axle and outboard of frame rails. The designed ride <br />height shall maintain original suspension's drive -line <br />geometry.___ <br />Tracking Bar: <br />The suspension shall utilize a lateral control rod (tracking <br />IWNO <br />bar) to maintain side to side axle position related to the <br />chassis frame. Wear shoes, mounted to the sides of the <br />frame rails are not acceptable. <br />Hydraulic <br />All hydraulic lines, fittings, reservoirs and valves shall be <br />NO <br />System: <br />protected against "stone pecking". Abrasion covers, such <br />as nylon convolute loom over the lines are required. The <br />entire assembled system shall be tested for leaks at every <br />fitting connection point.___ <br />Mechanical <br />All fasteners related to the suspension assembly are <br />M&NO <br />Q�uality <br />considered critical. All fasteners shall be tightened to the <br />Assurance: <br />manufacturer's recommended torque by the primary <br />installation mechanic. A secondary mechanic shall "put a <br />wrench" and re -torque ALL of the fasteners and then spray <br />a contrasting color of paint onto the heads and nuts of each <br />fastener. <br />Suspension <br />A suspension jounce clearance study shall be performed <br />II*NO <br />Jounce Study: <br />throughout the fall range of suspension travel to ensure <br />adequate clearance of suspension, frame and brake <br />components. Test results shall be documented and <br />s�uppli d in the owner's manual. <br />Kneeling <br />The rear suspension shall kneel when the triggering device <br />�'NWNO <br />Feature <br />is activated AND an enable switch, located in the cab <br />Enable: <br />console is activated, <br />Kneeling <br />The kneeling feature shall activate in PARK position only. <br />N*NO <br />Feature <br />The kneeling feature shall NOT activate in any forward or <br />Activation: <br />reverse gear, The above rear suspension shall kneel when <br />the trailing rear access door is opened. <br />Liquid Spring <br />Must include up to 16 hours of training for up to 4 <br />V*NO <br />Training <br />technicians. <br />fM&� #9) <br />17 <br />