Laserfiche WebLink
SUGGESTED FORMAT <br />(for use with E-500, 2008 Edition) <br />This is EXHIBIT C, consisting of 2 pages, referred to in <br />and part of the Agreement between Owner and Engineer for <br />Professional Services dated May 8, 2018, <br />Payments to Engineer for Services and Reimbursable Expenses <br />COMPENSATION PACKET BC-l: Basic Services — Lump Sum <br />Article 2 of the Agreement is supplemented to include the following agreement of the parties: <br />ARTICLE 2 — OWNER'S RESPONSIBILITIES <br />C2.01 Compensation for Basic Services (other than Resident Project Representative) -- Lump Sum Method <br />of Payment <br />A. Owner shall pay Engineer for Basic Services set forth in Exhibit A, except for services of <br />Engineer's Resident Project Representative, if any, as follows: <br />A Lump Sum amount of $45,450 based on the following estimated distribution of <br />compensation: <br />a. Pre -Design Phase $1 800 <br />b. Schematic Design Phase $18,475 <br />c. Construction Document Phase $8,675 <br />d. Bidding and Negotiating Phase $4,500 <br />e. Construction Administration Phase $1.2,000 <br />2. Engineer may alter the distribution of compensation between individual phases noted herein <br />to be consistent with services actually rendered, but shall not exceed tyre total Lump Sum <br />amount unless approved in writing by the Owner. <br />3. The Lump Sum includes compensation for Engineer's services and services of Engineer's <br />Consultants, if any. Appropriate amounts have been incorporated in the Lump Sum to <br />account for labor, overhead, profit, and Reimbursable Expenses. <br />4. The portion of the Lump Sum amount billed for Engineer's services will be based upon <br />Engineer's estimate of the percentage of the total services actually completed during the <br />billing period. <br />Page t <br />Exhibit C —Compensation Packet BC -I: Basic Services (other than RPR) — Lump Swn Metbod of Payment <br />EJCDC E-500 Agreement Behveen Owner and Engineer for Professional Services. <br />Copyright O 2008 National Society of Professional Engineers for EdCDC. All rights reserved. <br />