Laserfiche WebLink
(Body cont'd) <br />13. Forks shall be designed to provide the necessary dump angle to assure 00 <br />complete discharge of materials fi-om the refuse containers. <br />14. Lift arms shall be brought to a smooth stop in the raised and lowered G)/NO <br />position by use of hydraulic arm cylinders. <br />15. Heavy dut ' y bolt -on hard rubber arms stops located at the side of the (aO <br />body will cushion and prevent over travel of the lift arms. <br />16. Maximum height with the lift arms raised in the full up and forks fully YOE No <br />tucked position will be 13'6" (based on a chassis rail height of 42"). <br />17. An in -cab mounted warning light will be provided to indicate when any 1@NO <br />part of the arms are raised above the body. <br />F, Hydraulics <br />1. The maximum operating pressure of the system will be 2500 PSI. <br />2. The hydraulic pump shall be a PTO mounted, load sensing HAWE <br />Y%ES <br />piston pump with minimum working pressure of 3000psi with load <br />sensing capability. It shall have the capability of producing 40 GPM <br />when mounted to a 116% PTO at an engine speed of 120ORPM. It shall <br />have an electronic over -speed control and shall be capable of producing <br />the required flow to sustain both the Automated or Semi -Automated <br />Carry Can and the packing panel of the unit. <br />3. Pump -to -body hard plumbing shall be provided and shall be securely <br />OY�E INO <br />supported and clamped to prevent vibration, abrasion, and excessive noise. <br />Flex hoses shall be provided at each end of the hard plumbing to provide <br />adequate flexure to prevent hydraulic leaks. <br />4. The pressure side of the hydraulic system shall be filtered by a high <br />@No <br />pressure filter capable of handling 3000 psi hydraulic pressure with a 50 <br />psi bypass pressure and shall filter to a 5 micron filtration level with a beta <br />of >200. The filter housing shall be equipped with a visual indicator that <br />indicates when the filter element should be replaced. <br />G. Curotto/Carry Can Hydraulics <br />1. The Curotto/Carry Can hydraulics shall be routed down the streetside arm <br />CYE::S�O <br />in a manner to prevent damage from tree limbs and other obstacles. <br />2. Hydraulic Hoses <br />a. All hydraulic hoses shall conform to S.A,E standards for designed <br />(91NO <br />pressure. Bends shall not be more than recommended by S.A.E. <br />standards. Flat Spots in hoses will not be acceptable. 4 wire hoses are <br />not utilized due to reduced bend radius and increased opportunities for <br />loosened fittings. <br />b. All pressure hoses shall be protected with fabric guard. <br />0 <br />3. Hydraulic Oil Reservoir <br />a. The hydraulic oil reservoir shall have a gross capacity of 47 gallons <br />YES 0 <br />filled with 41 gallons of hydraulic fluid. <br />9 <br />b. The tank shall be complete with a screened fill pipe and cap, filter <br />E 0 <br />breather, clean out cover, shut off valve, oil level sight, and temperature <br />gauge. <br />17 <br />