Laserfiche WebLink
(Body contd) <br />13. Forks shall be designed to provide the necessary dump angle to assure <br />YES/NO <br />complete discharge of materials from the refuse containers. <br />14. Lift arms shall be brought to a smooth stop in the raised and lowered <br />YESNO <br />position by use of hydraulic arm cylinders. <br />15. Heavy duty bolt -on hard rubber arms stops located at the side of the <br />]LES/N0 <br />body will cushion and prevent over travel of the lift arms. <br />16. Maximum height with the lift arms raised in the full up and forks fully <br />YL&NO <br />tucked position will be 13'6" (based on a chassis, rail height of 42"). <br />17. An in -cab mounted warning light will be provided to indicate when any <br />L]a/N0 <br />part of the arms are raised above the body. <br />F. Hydraulics <br />1. The maximum operating pressure of the system will be 2500 PSI. YE <br />I/NO <br />2. The hydraulic pump shall be a PTO mounted, load sensing HAWE YES/NO <br />piston pump with minimum working pressure of 3000psi with load <br />sensing capability. It shall have the capability of producing 40 GPM <br />when mounted to a 116% PTO at an engine speed of 12 OORPM. It shall <br />have an electronic over -speed control and shall be capable of producing <br />the required flow to sustain both the Automated or Semi -Automated <br />Carry Can and the packing panel of the unit. <br />3. PumD-to-body hard plumbing shall be provided and shall be securely LESNO <br />supported and clamped to prevent vibration, abrasion, and excessive noise. <br />Flex hoses shall be provided at each end of the hard plumbing to provide <br />ade�quate flexure to prevent hydraulic leaks. <br />4. The pressure side of the hydraulic system shall be filtered by a high YES/NO <br />pressure filter capable of handling 3000 psi hydraulic pressure with a 50 <br />psi bypass pressure and shall filter to a 5 micron filtration level with a beta <br />of >200. The filter housing shall be equipped with a visual indicator that <br />indicates when the filter element should be replaced. <br />G. Curotto/Carry Can Hydraulics <br />1. The Curotto/Carry Can hydraulics shall be routed down the streetside arm <br />YESNO <br />in a manner to prevent damage from tree limbs and other obstacles. <br />2. Hydraulic Hoses <br />a. All hydraulic hoses shall conform to S.A.E standards for designed <br />YESNO <br />pressure. Bends shall not be more than recommended by S.A.E. <br />standards. Flat Spots in hoses will not be acceptable. 4 wire hoses are <br />not utilized due to reduced bend radius and increased opportunities for <br />loosened fittings. <br />b. All pressure hoses shall be protected with fabric guard. <br />YLS-/NO <br />3. Hydraulic Oil Reservoir <br />a. The hydraulic oil reservoir shall have a gross capacity of 47 gallons <br />LES/NO <br />filled with 41 gallons of hydraulic fluid. <br />b. The tank shall be complete with a screened fill pipe and cap, filter <br />YES/NO <br />breather, clean out cover, shut off valve, oil level sight, and temperature <br />gauge. <br />17 <br />