Laserfiche WebLink
SUGGESTED FORMAT <br />(for use with E-500, 2008 Edition) <br />This is EXHIBIT C, consisting of 2 pages, referred to in <br />and pant of the Agreement between Owner and Engineer for <br />Professional Set -vices dated July 25, 2017. <br />Payments to Engineer for Services and Reimbursable Expenses <br />COMPENSATION PACKET BC-1: Basic Services — Lump Sum <br />Article 2 of the Agreement is supplemented to include the following agreement of the parties. - <br />ARTICLE 2 — OWNER'S RESPONSIBILITIES <br />C2.01 Compensation for Basic Services (other than Resident Project Representative) —Lump Sum Method <br />of Payment <br />A. Owner shall pay Engineer for Basic Services set forth in Exhibit A, except for services of <br />Engineer's Resident Project Representative, if any, as follows: <br />1. A Lump Sum amount of $285,570 based on the following estimated distribution of <br />compensation: <br />a. Pre -Design Phase $38,120 <br />b. Schametic Design Phase $49,600 <br />c. Design Development Phase $24,800 <br />d. Construction Document Phase $86,800 <br />e. Bidding and Negotiation Phase $12 500 <br />f. Construction Administration Phase $49 300 <br />g. LEED Silver Commissioning $15,000 <br />h. LEED Silver Documentation $9 450 <br />1) Includes USGBC application fees <br />2. Engineer may alter the distribution of compensation between individual phases noted herein <br />to be consistent with services actually rendered, but shall not exceed the total Lump Sum <br />amount unless approved in writing by the Owner. <br />Page I <br />Exhibit C —Compensation Packet BC-1: Bad Servioes(other than RPR)—Lump Sum Method of Payment <br />EJCCC E-6WAgremml Between Owner and Engineer for Professional Services, <br />Copyright cC 2008 National Society of Professional Engineers for EJCUC. All rights reserved. <br />