Laserfiche WebLink
I:AWANN ti * ,F <br />1. Mountable medians with delineator posts shall consist of a curb system, profile reflectors, <br />and reboundabie delineator posts as specified in this section. <br />a. Curb System: <br />(i) Shall be designed to affix to the asphalt roadway with anchor bolts <br />(ii) Shall be made of high -impact plastic <br />(iii) Shall be yellow <br />(iv) Shall have sloping sides <br />(v) Shall have a compressive strength of at least 3,500 psi at 10% deformation of <br />sample's original height. A letter from an independent engineering testing <br />laboratory reporting the test results of a representative curb section shall be <br />submitted with the quote. <br />(vi) Shall consist of interlocking curb segments with end caps at the beginning and end <br />of each run of curb <br />(i) Curb segments: <br />1. Shall meet the following dimension requirements: <br />Dimension <br />Minimum <br />Maximum <br />Height <br />3 in. <br />4 in. <br />Width <br />10 in. <br />12 in. <br />Lenath <br />3 ft <br />4 ft <br />2. Each curb segment shall have a receptacle for one <br />reboundable delineator post. <br />3. Each curb segment shall include a minimum of one <br />profile reflector unit on its surface or shall have a <br />receptacle for a profile reflector. <br />(ii) End caps: <br />1. Shall fasten to the curb segments and taper from the <br />height of the curb segment to a height no greater than <br />1/2 in <br />b. Profile reflectors: <br />(i) Shall be integrated into each curb segment or manufactured to fasten to each <br />curb segment <br />(ii) Shall be replaceable <br />(iii) Shall include retro-reflective units at the top and sides of curb segment as <br />installed. <br />c. Reboundabie Delineator Posts: <br />Y r _ _ n !11% 11%C 11 6 <br />